Specifications, descriptions and illustrative material in this literature are as accurate as known at the time of publication, but are subject to chan
10 X7722271408© 3/2014 ECHO Inc.DESCRIPTION SRM-225UDESCRIPTIONLocate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you
SRM-225U DESCRIPTIONX7722271408 11© 3/2014 ECHO Inc.1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter.2. TH
12 X7722271408© 3/2014 ECHO Inc.CONTENTS SRM-225UCONTENTSThe ECHO product you purchased has been factory pre-assembled for your convenience. Due to pa
SRM-225U ASSEMBLYX7722271408 13© 3/2014 ECHO Inc.ASSEMBLYPlastic Shield Installation(Nylon line operation)The plastic shield is for use with the Nylon
14 X7722271408© 3/2014 ECHO Inc.ASSEMBLY SRM-225U3. Thread line head (J) onto PTO shaft by turning it counter-clockwise until head is tight against up
SRM-225U ASSEMBLYX7722271408 15© 3/2014 ECHO Inc.a. Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool
16 X7722271408© 3/2014 ECHO Inc.ASSEMBLY SRM-225U4. Insert Cotter Pin (C) in hole in PTO shaft, and bend pin legs around shaft counterclockwise to ret
SRM-225U ASSEMBLYX7722271408 17© 3/2014 ECHO Inc.4. Connect 2 ignition stop leads (F, G) from throttle cable tubing to 2 ignition leads (F, G) on engi
18 X7722271408© 3/2014 ECHO Inc.OPERATION SRM-225UOPERATIONMoving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose
SRM-225U OPERATIONX7722271408 19© 3/2014 ECHO Inc.Note: The Barrier Bar is used to restrict rearward movement of the unit. The Barrier Bar is NOT A HA
2 X7722271408© 3/2014 ECHO Inc.TABLE OF CONTENTS SRM-225UTABLE OF CONTENTSTable of Contents ...
20 X7722271408© 3/2014 ECHO Inc.OPERATION SRM-225UNote: In case of Emergency, pull up on the Quick Release Collar to disconnect the trimmer from the
SRM-225U OPERATIONX7722271408 21© 3/2014 ECHO Inc.• Inspect for fuel leakage. If fuel leakage is found, do not start or operate unit until leakage is
22 X7722271408© 3/2014 ECHO Inc.OPERATION SRM-225UStarting Cold EngineThe attachment will operate immediately when the engine starts, and could result
SRM-225U OPERATIONX7722271408 23© 3/2014 ECHO Inc.Starting Warm EngineThe starting procedure is the same as Cold Start except DO NOT close the choke,
24 X7722271408© 3/2014 ECHO Inc.MAINTENANCE SRM-225UMAINTENANCEMoving parts can amputate fingers or cause severe injuries. Keep hands, clothing and lo
SRM-225U MAINTENANCEX7722271408 25© 3/2014 ECHO Inc.Air FilterLevel 1.1. Close choke (Cold Start Position [ ]). This prevents dirt from entering the c
26 X7722271408© 3/2014 ECHO Inc.MAINTENANCE SRM-225USpark PlugLevel 2.Use only NGK BPM-8Y spark plug (BPMR-8Y in Canada) otherwise severe engine damag
SRM-225U MAINTENANCEX7722271408 27© 3/2014 ECHO Inc.2. Remove air cleaner cover (A).3. Remove engine cover (B).DO NOT use a metal scraper to remove di
28 X7722271408© 3/2014 ECHO Inc.MAINTENANCE SRM-225UExhaust Port CleaningLevel 2.1. Remove spark plug lead from spark plug, and remove engine cover.2.
SRM-225U MAINTENANCEX7722271408 29© 3/2014 ECHO Inc.Note: Every unit is run at the factory and the carburetor is set in compliance with emission regu
SRM-225U INTRODUCTIONX7722271408 3© 3/2014 ECHO Inc.INTRODUCTIONWelcome to the ECHO family. This ECHO product was designed and manufactured to provide
30 X7722271408© 3/2014 ECHO Inc.MAINTENANCE SRM-225UNylon Line Head Disassembly InstructionsNote: For normal use, Speed Feed® head disassembly is not
SRM-225U MAINTENANCEX7722271408 31© 3/2014 ECHO Inc.When the wear indicators located at the bottom of the Speed-Feed® head are worn smooth, or if hole
32 X7722271408© 3/2014 ECHO Inc.MAINTENANCE SRM-225U3. After sharpening teeth, check each tooth radius for evidence of a square (sharp) corner. Use th
SRM-225U TROUBLESHOOTINGX7722271408 33© 3/2014 ECHO Inc.TROUBLESHOOTINGFuel vapors are extremely flammable and may cause fire and/or explosion. Never
34 X7722271408© 3/2014 ECHO Inc.STORAGE SRM-225USTORAGEDuring operation the muffler or catalytic muffler and surrounding cover become hot. Always keep
SRM-225U SPECIFICATIONSX7722271408 35© 3/2014 ECHO Inc.SPECIFICATIONSMODEL SRM-225ULength 1793 mm (70.6 in.) Width 700 mm (27.5 in.) Height 510 mm (20
36 X7722271408© 3/2014 ECHO Inc.WARRANTY STATEMENTS SRM-225UWARRANTY STATEMENTSECHO LIMITED WARRANTY STATEMENT FOR PRODUCT SOLD IN USA AND CANADA BEGI
SRM-225U WARRANTY STATEMENTSX7722271408 37© 3/2014 ECHO Inc. PURCHASED REPAIR PARTS, SHORT BLOCKS AND ACCESSORIESGD\UHVLGHQWLDORUQRQLQFRPH
38 X7722271408© 3/2014 ECHO Inc.NOTES SRM-225UNOTES
SRM-225U NOTESX7722271408 39© 3/2014 ECHO Inc.
4 X7722271408© 3/2014 ECHO Inc.SAFETY SRM-225UAdditional or Replacement ManualsReplacement Operator, Safety Manuals, and Parts Catalogs are available
ECHO, INCORPORATED400 Oakwood RoadLake Zurich, IL 60047www.echo-usa.com40S79111001030/S79111999999S79012004906/S79012999999
SRM-225U SAFETYX7722271408 5© 3/2014 ECHO Inc.International Symbols Symbol Description Symbol Description Symbol Description Symbol DescriptionWarning
6 X7722271408© 3/2014 ECHO Inc.SAFETY SRM-225UPersonal Condition and Safety EquipmentUsers of this product risk injury to themselves and others if the
SRM-225U SAFETYX7722271408 7© 3/2014 ECHO Inc.The ignition componentsof this machine generate an electromagnetic fieldduring operation which may int
8 X7722271408© 3/2014 ECHO Inc.SAFETY SRM-225UAll over head electrical conductors and communications wires can have electricity flow with high voltage
SRM-225U EMISSION CONTROL (EXHAUST & EVAPORATIVE)X7722271408 9© 3/2014 ECHO Inc.Moving parts can amputate fingers or cause severe injuries. Keep h
Commentaires sur ces manuels