Echo CS-500P Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Outil à essence Echo CS-500P. Echo CS-500P User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 34
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
INSTRUCTION MANUAL
CHAIN SAW
CS-500P
WARNING
Read the instructions carefully and follow the rules for safe
operation.
Failure to do so could result in serious injury.
X750-017 71 4
X750 331-000 4
ECHO, INCORPORATED
400 Oakwood Road, Lake Zurich, Illinois 60047-1564
Phone : 847-540-8400
Printed in Japan 1311/12F 0798 ES
Vue de la page 0
1 2 3 4 5 6 ... 33 34

Résumé du contenu

Page 1 - CHAIN SAW

INSTRUCTION MANUALCHAIN SAWCS-500P WARNINGRead the instructions carefully and follow the rules for safe operation.Failure to do so could result in s

Page 2 - WARNING

8CS-500POPERATOR SAFETYVIBRATION AND COLDs )TISBELIEVEDTHATACONDITIONCALLED2AYNAUDSPhenomenon, which affects the fingers of certain individua

Page 3 - RULES FOR SAFE OPERATION

9CS-500PSPARK ARRESTOR MUFFLERs 4HESPARKARRESTORMUFmERCONTROLSTHEEXHAUSTnoise and prevents hot, glowing particles of carbon from leaving the

Page 4 - B. Other Safety Precautions

10CS-500P WARNINGSaw chain is sharp! Always wear gloves when handling assembly, otherwise serious personal injury may result.GUIDE BAR AND SAW CHAIN

Page 5 - CONTENTS

11CS-500PADJUSTING CHAIN TENSIONIMPORTANTAlways loosen clutch cover nuts before turning the chain tension adjuster, otherwise the clutch cover and ten

Page 6 - SYMBOL FORM

12CS-500PFuel Mix Chart 50 : 1U.S. MetricGasoline Oil Gasoline OilGallons US. fl. oz. L mL1 2.6 4 802 5.2 8 1605 12.8 20 400FUEL AND LUBRICANTFUEL STAT

Page 7 - PACKING LIST

13CS-500PHANDLING FUELMIXING INSTRUCTIONS - 1. Fill an approved fuel container with half of the required amount of gasoline. 2. Add the proper amount

Page 8 - NOMENCLATURE OF PARTS

14CS-500P WARNINGs!FTERCHOKECONTROLKNOBISPULLEDANDTHENknob is returned to original position, throttle remains a little open (latch conditio

Page 9

15CS-500PWHEN THE ENGINE IS COLD CAUTIONMake sure the bar and chain are free from any obstruction when starting the chain saw. s -OVECHAINBRAKEL

Page 10 - OPERATOR SAFETY

16CS-500PRUNNINGs 7HENENGINESTARTSKEEPIDLINGFORAFEW minutes. s 3ETTHEBRAKELEVERINTHEUNLOCKEDPOSITION before starting to cut. s 0UL

Page 11 - CORRECT USE OF CHAIN BRAKE

17CS-500PCUTTING INSTRUCTIONGENERAL CAUTIONs2EADTHE%#(/h#(!).3!73!&%49MANUAL” included with your chain saw for additional cutting and saf

Page 12 - PREPARATION FOR USE

Copyright © 2010 All Rights Reserved.The engine exhaust from this product contains chemicals known to the State of California to cause cancer, bir

Page 13 - ADJUSTING CHAIN TENSION

18CS-500PFELLING THE TREEA falling tree can seriously damage anything it may hit - a car, a house, a fence, a power-line, or another tree. There are

Page 14 - FUEL AND LUBRICANT

19CS-500PLIMBINGLimbing a fallen tree is much the same as bucking. Never stand on the tree that you are limbing. When limbing, caution is the word. B

Page 15 - EMISSION DATA

20CS-500PChain brake functionWhen the lever is pushed forward, chain brake instantly stops the chain. Chain brake unlockWhen the lever is fully pulled

Page 16 - OPERATION

21CS-500PEnd of the guide bar may be placed at the height of about 35 cm (14 in.).35 cm(14 in.)AUTOMATIC CHAIN BRAKEKickback produced from the tip of

Page 17 - WHEN THE ENGINE IS WARM

22CS-500PCHAIN AND GUIDE BAR COMBINATIONThe following combinations are recommended for model CS-500P. GUIDE BAR(Low-kickback)Replacement guide bars.

Page 18 - CHAIN LUBRICATION TEST

23CS-500PMAINTENANCE AND CAREIMPORTANTTime intervals shown are maximum. Actual use and your experience will determine the frequency of required maint

Page 19 - CUTTING INSTRUCTION

24CS-500PCARBURETOR ADJUSTMENTEvery unit is run at the factory and the carburetor is set in compliance with Emission Regulations. In addition, the ca

Page 20 - FELLING THE TREE

25CS-500PFuel filterFuel tank cap0.65 mm (0.026 in.)Cleaner cover knobAir filterAir cleaner coverAIR FILTERs #HECKBEFOREEVERYUSEs #LOSECHOKE )

Page 21 - DANGER

26CS-500PGUIDE BARs #LEANBEFOREUSING- Clean the groove of the guide bar with a small screwdriver. - Clean oil holes with a wire.s 2EVERSEGUID

Page 22 - TESTING THE BRAKE

27CS-500PSETTING THE SAW CHAINSharpen lower edgeDrive linkTie strapRight hand cutterPreset tie strapLeft hand cutterGuard linkTop plateSide plateDepth

Page 23 - WINTER OPERATION

1CS-500PRULES FOR SAFE OPERATIONA. Kickback Safety Precautions for Chain Saw Users 1. With a basic understanding of kickback, you can reduce or elimi

Page 24 - SAW CHAIN

28CS-500Ps 0LACETHEDEPTHGAUGETOOLlRMLYONGUIDEBARso that depth gauge protrudes. Then file top of depth gauge with the flat file until flat with

Page 25 - MAINTENANCE AND CARE

29CS-500PTROUBLESHOOTING WARNINGFuel vapors are extremely flammable and MAYCAUSElREANDOREXPLOSION.EVERTESTfor ignition spark by grounding sp

Page 26 - CARBURETOR ADJUSTMENT

30CS-500PSTORAGE AFTER USE* Technical data subject to change without notice.TECHNICAL DATAs )NSPECTANDADJUSTEVERYPARTOFTHECHAINSAW- Compl

Page 27 - OIL FILTER

31CS-500PWARRANTY STATEMENTSECHO LIMITED WARRANTY STATEMENT FOR PRODUCT SOLD IN USA AND CANADA BEGINNING 01/01/2010ECHO’S RESPONSIBILITYECHO Incorpor

Page 28 - AUTOMATIC OILER

32CS-500PPURCHASED REPAIR PARTS, SHORT BLOCKS AND ACCESSORIESsDAYRESIDENTIALORNONINCOMEPRODUCINGWARRANTYsDAYCOMMERCIALINSTITUTIONAL

Page 29 - SETTING THE SAW CHAIN

2CS-500P 1. Do not operate a chain saw with one hand! Serious injury to the operator, helpers, bystanders, or any combination of these persons may re

Page 30

3CS-500P WARNINGThe safety alert symbol accompanied by the word “WARNING” calls attention to an act or condition which CAN lead to serious personal

Page 31 - TROUBLESHOOTING

4CS-500PSYMBOL FORMDECALSLocate this safety decal on your unit. The complete unit illustration found in the “NOMENCLATURE OF PARTS” section will help

Page 32 - TECHNICAL DATA

5CS-500PPACKING LISTThe ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, guide bar and

Page 33 - WARRANTY STATEMENTS

6CS-500PNOMENCLATURE OF PARTS* If a decal cannot be read, a new one can be ordered from your ECHO dealer. 1914 15171654871011 12321X524-003551X505-00

Page 34 - C19312001001/C19312999999

7CS-500P 1. Instruction manual - Included with unit. Read before operation and keep for future reference to learn proper, safe operating techniques.

Commentaires sur ces manuels

Pas de commentaire