Echo SRM - 410U Manuel d'utilisateur télécharger pdf (Page 20)

s t a r t I n g c o l d e n g I n e

WARNING

When engine is started, conrm that there is not any abnormal

vibration or sound. If there is abnormal vibration or sound, ask

your DEALER to repair. After refueling tighten fuel cap rmly and

check for leakage. In case of fuel leakage repair before starting

operation since there is a danger of re.

1. Stop Switch

Move stop switch button (A) forward away from the STOP posi-

tion.

2. Choke

Move choke lever (B) to Cold Start Position ( ).

3. Purge Bulb

Pump purge bulb (C) until fuel is visible and ows freely in the

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4. Press the decompression device (E).

5. Recoil Starter

Lay the unit on a at area and keep movable attachment parts clear

of all obstacles. Hold unit rmly, and rapidly pull recoil starter

handle/rope (D) until engine res (or maximum ve [5] pulls).

NOTE

Starter handle : Use short pulls - only 1/2 - 2/3 of starter rope for

starting. Do not let starter rope snap back in.

Always hold the unit rmly.

6. Choke

After engine res (or 5 pulls), move choke lever back to Run

(

) position. Pull recoil starter starter handle/rope until engine

starts and runs. Allow unit to warm up at idle for several minutes.

NOTE

If engine does not start with choke in “Run” position after 5 pulls,

repeat instructions 2 - 5.

7. Throttle Trigger

After engine warm-up, gradually depress throttle trigger to increase

engine RPM to operating speed.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Pas de commentaire

Echo SRM - 410U Manuel d'utilisateur Page 20