Echo SRM-280 Manuel d'utilisateur télécharger pdf (Page 10)

n y l o n l I n e h e a d I n s t a l l a t I o n

Tools Required: Head Locking Tool.

Parts Required: Nylon Line Head.

CAUTION

Wear Gloves or personal injury may result:

• Cutoff knife is sharp.

• Gearcase and surrounding area may be hot.

1. Be sure adapter plate (C) remains on PTO shaft (A).

2. Align locking hole in upper plate with notch in edge of gear hous-

ing and insert head locking tool (D).

3. Thread line head (E) onto shaft by turning it counter-clockwise

until head is tight against adapter plate (C).

4. Remove locking tool (D).

t o a d v a n c e t r I m m e r l I n e

Tip:

To advance trimmer line, tap trimmer head against the ground

while the head is turning at normal operating speed.

IMPORTANT

Semi-automatic nylon line heads must be used only with plastic

debris shield with cut-off knife. Using nylon line heads with metal

debris shield can result in trimmer damage, caused by operation

with excessive line length.

n y l o n l I n e r e p l a c e m e n t

See Maintenance Section for nylon line replacement.

r e m o v e n y l o n l I n e h e a d

NOTE

Do not disassemble nylon line head.

1. Align locking hole in upper plate with notch in edge of gear hous-

ing and insert head locking tool (D).

2. Remove line head (E) by turning it clockwise until head is com-

pletely off of shaft.

3. Remove locking tool (D).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Pas de commentaire

Echo SRM-280 Manuel d'utilisateur Page 10