Echo PPT-260 Manuel d'utilisateur télécharger pdf (Page 11)

POWER PRUNER

OPERATOR'S MANUAL

WARNING

Saw Chain is sharp! Always wear gloves when handling assembly,

otherwise serious personal injury may result.

1. Loosen the four (4) screws (D) and locator screw (E) on cutting

attachment.

2. Loosen center clamp knob (F) turning counter clockwise.

3. Pull upper tube (G) out of fiberglass lower tube 127-152 mm (5-6 in.),

then slide (G) back into fiberglass lower tube exposing inner drive

shaft (H). Align and join star shaped drive end of inner drive shaft

(H) with cutting attachment shaft (I).

4. Align ridges on upper tube (G) with seams in cutting attachment.

5. Slide together aligning locator screw (E) in cutting attachment with

locating hole (J) in upper tube.

6. Tighten locator screw (E). Tighten four (4) cutting attachment

screws (D).

7. Extend upper tube to desired length. Tighten center clamp knob (F)

turning clockwise.

CUTTING ATTACHMENT TO DRIVE SHAFT INSTALLATION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

Echo PPT-260 Manuel d'utilisateur Page 11