Echo SRM-280 Manuel d'utilisateur télécharger pdf (Page 9)

Gr a s s Tr i m m e r /Br u s h Cu T T e r

Op e r a T O r 's ma n u a l

co n t e n t s

The ECHO product you purchased has been partially assembled for your convenience. Due to packaging restrictions,

installation of the plastic debris shield, nylon line head, and positioning of the front handle are necessary.

After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing

parts. Use the contents list to check for missing parts.

* Some units may be factory pre-assembled. No assembly tools are needed and the nylon line head, plastic debris shield,

and mounting hardware, shown in the contents list, are pre-assembled to the unit. Only the front handle may need to be

re-positioned for comfortable operation.

_______1 - Power Head / Drive Shaft Assembly

______ - 1, Operator's Manual

______ - 1, Safety Manual

______ - 1, Warranty Registration Card

_______ - 1, Safety Glasses

* _____ - 1, Nylon Trimmer Head

* _____ - 1, wrench 17x19

* _____ - 1, locking tool

* _____ --1, Plastic shield

* _____ --1, shield plate

* _____ --3, 5mm x 16mm screws (shield mtg.)

as s e m b l y

p l a s t I c

s h I e l d I n s t a l l a t I o n

(for Nylon Line Operation)

Tools Required: Screwdriver.

Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 16mm

screws.

NOTE

The plastic shield is for use with the Nylon Line Head only.

Install Metal Shield when using plastic or metal blades.

1. Remove plastic threaded shaft sleeve and adapter plate (C) from

PTO shaft (A).

2. Place the shield on the bottom of the bearing housing ange.

3. Place shield plate (B) on shield, align holes. Install three (3) screws

from bottom through plate and shield into gear case.

4. Assemble adapter plate (C) onto PTO shaft.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Pas de commentaire

Echo SRM-280 Manuel d'utilisateur Page 9