Echo PPT-230 Manuel d'utilisateur télécharger pdf (Page 14)

Mixing Instructions

1. Fill an approved fuel container with half of the required amount of

gasoline.

2. Add the proper amount of 2-stroke oil to gasoline.

3. Close container and shake to mix oil with gasoline.

4. Add remaining gasoline and remix.

5. Install fuel container cap and wipe any spilled fuel from container

and surrounding area.

Handling Fuel

WARNING DANGER

Fuel is VERY flammable. Use extreme care when mixing, storing or

handling, or serious personal injury may result.

• Use an approved fuel container.

• DO NOT smoke near fuel.

• DO NOT allow flames or sparks near fuel.

• Fuel tanks/cans may be under pressure. Always loosen fuel caps

slowly allowing pressure to equalize.

• NEVER refuel a unit when the engine is HOT!

• NEVER refuel a unit with the engine running.

• DO NOT fill fuel tanks indoors. ALWAYS fill fuel tanks out

doors over bare ground.

• Securely tighten fuel cap after refueling.

• Inspect for fuel leakage. If fuel leakage is found, do not start or

operate unit until leakage is repaired.

IMPORTANT

Spilled fuel is a leading cause of hydrocarbon emissions. Some

states may require the use of automatic fuel shut-off containers

to reduce fuel spillage. Contact your ECHO dealer for ordering

information.

After Refueling

• Wipe any spilled fuel from the unit.

• Move at least 3 m (10 ft.) from refueling

location before starting the engine.

After use

• DO NOT store a unit with fuel in its tank.

Leaks can occur. Return unused fuel to an

approved fuel storage container.

Storage

Fuel storage laws vary by locality. Contact

your local government for the laws affecting

your area. As a precaution, store fuel in an

approved, airtight container. Store in a well

ventilated, unoccupied building, away from

sparks and flames. Do not store fuel longer

than 30 days.

IMPORTANT

Stored fuel ages. Do not mix more fuel

than you expect to use in thirty (30)

days, ninety (90) days when a fuel

stabilizer is added.

IMPORTANT

Stored two-stroke fuel may separate.

ALWAYS shake fuel container thor-

oughly before each use.

LUBRICATING THE GUIDE BAR AND SAW CHAIN

Automatic Oiling System

1. Wipe debris from around oil fill cap.

2. Remove oil fill cap, and fill reservoir with a quality, low-viscosity

guide bar and saw chain oil.

NOTE

The discharge volume of the automatic oiler is preset to deliver 3 to

4 cc/min. at normal operating RPM. During heavy or dry cutting

conditions, the oil discharge volume may be adjusted to assure

adequate lubrication. Refill the oil reservoir with each tank of fuel.

IMPORTANT

To prevent plastic deterioration, do not use synthetic or silicone

based oil.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Echo PPT-230 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Echo PPT-230