Echo PPT-265S Manuel d'utilisateur télécharger pdf (Page 14)

throttle lInkage and IgnItIon leads

1. Install throttle linkage cable into fan cover clip (A).

2. Close choke and remove air lter cover.

3. Place throttle linkage (B) through adjustment xture (C) and install

wire end into large carburetor throttle swivel hole (D). Check

throttle for freedom of movement and that wide open throttle / low

idle extremes are adjusted properly. The throttle linkage must be

adjusted by moving the adjustment xture (C). Consult with your

Echo Dealer for correct adjustment procedure.

4. Connect 2 ignition stop leads (E, F) from throttle cable tubing to 2

ignition leads (E, F) on engine.

CAUTION:

Assure ignition terminals are completely covered by clear plastic

sleeves.

5. Secure ignition leads against engine housing with clip (G).

6. Install air lter and cover.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Pas de commentaire

Echo PPT-265S Manuel d'utilisateur Page 14