Echo CS-8000 TYPE1-E Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Scies à chaîne Echo CS-8000 TYPE1-E. Echo CS-8000 TYPE1-E User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer

Résumé du contenu

Page 1 - CS-8000 TYPE1-E

INSTRUCTION MANUALCHAIN SAW WARNINGRead the instructions carefully and follow the rules for safeoperation.Failure to do so could result in serious i

Page 2 - WARNING

8CS-8000 TYPE1-EVIBRATION AND COLD• It is believed that a condition called Raynaud’sPhenomenon, which affects the fingers of certainindividuals, may b

Page 3 - RULES FOR SAFE OPERATION

9CS-8000 TYPE1-ESPARK ARRESTOR MUFFLER• The spark arrestor muffler controls the exhaustnoise and prevents hot, glowing particles ofcarbon from leaving

Page 4 - B. Other Safety Precautions

10CS-8000 TYPE1-EPREPARATION FOR USE WARNINGSaw chain is sharp! Always wear gloveswhen handling assembly, otherwise seriouspersonal injury may resul

Page 5 - SYMBOLS AND SIGNS

11CS-8000 TYPE1-EADJUSTING CHAIN TENSIONIMPORTANTAlways loosen clutch cover nuts before turningthe chain tension adjuster, otherwise the clutchcover a

Page 6 - SYMBOL FORM

12CS-8000 TYPE1-EFUEL AND LUBRICANTFuel Mix Chart 50 : 1US. METRICGasoline Oil Gasoline OilGallons US. fl. oz. L mL1 2.6 4 802 5.2 8 1605 12.8 20 400F

Page 7 - PACKING LIST

13CS-8000 TYPE1-EHANDLING FUELMIXING INSTRUCTIONS -1. Fill an approved fuel container with half of therequired amount of gasoline.2. Add the proper am

Page 8 - NOMENCLATURE OF PARTS

14CS-8000 TYPE1-EOil tank capFuel tank capCap indicationFuel/oil tanks are indicated by the followingillustrations on the caps.CHAIN LUBRICANTProper l

Page 9 - NOMENCLATURE OF PARTS

15CS-8000 TYPE1-EWHEN THE ENGINE IS WARM• Move chain brake lever fully forward to lock chainbrake before starting.• Confirm there is fuel and chain oi

Page 10 - OPERATOR SAFETY

16CS-8000 TYPE1-ESTOPIgnition switchRUNNING• When engine starts, keep idling for a fewminutes.• Set the brake lever in the unlocked positionbefore sta

Page 11 - CORRECT USE OF CHAIN BRAKE

17CS-8000 TYPE1-ECUTTING INSTRUCTIONGENERAL CAUTION• Read the ECHO “CHAIN SAW SAFETYMANUAL” included with your chain saw foradditional cutting and s

Page 12 - PREPARATION FOR USE

Copyright © 2002 All Rights Reserved.The engine exhaust from thisproduct contains chemicals knownto the State of California to causecancer, birth d

Page 13 - ADJUSTING CHAIN TENSION

18CS-8000 TYPE1-EFELLING THE TREEA falling tree can seriously damage anything it mayhit - a car, a house, a fence, a power-line, oranother tree.There

Page 14 - FUEL AND LUBRICANT

19CS-8000 TYPE1-ELIMBINGLimbing a fallen tree is much the same as bucking.Never stand on the tree that you are limbing.When limbing, caution is the wo

Page 15 - HANDLING FUEL

20CS-8000 TYPE1-ECHAIN BRAKE OPERATION• Set the lever in the unlocked position beforestarting to cut.• If the brake is tripped by kickback reaction, t

Page 16 - OPERATION

21CS-8000 TYPE1-ECHAIN AND GUIDE BAR COMBINATIONThe following combinations are recommended for model CS-8000 TYPE1-E.Guide Bar Saw chainLength ECHO Pa

Page 17 - WHEN THE ENGINE IS HARD TO

22CS-8000 TYPE1-EMAINTENANCE AND CAREIMPORTANTTime intervals shown are maximum.Actual use and your experience will determinethe frequency of required

Page 18 - CHAIN LUBRICATION TEST

23CS-8000 TYPE1-ECARBURETOR ADJUSTMENTEvery unit is run at the factory and the carburetor isset in compliance with Emission Regulations. Inaddition, t

Page 19 - CUTTING INSTRUCTION

24CS-8000 TYPE1-E0.65 mm (0.026 in.)AIR FILTER• Check before every use.• Loosen cleaner cover knob and remove aircleaner cover and filter.• Brush off

Page 20 - FELLING THE TREE

25CS-8000 TYPE1-EGUIDE BAR• Clean before using.- Clean the groove of the guide bar with a smallscrewdriver.- Clean oil holes with a wire.• Check sproc

Page 21 - DANGER

26CS-8000 TYPE1-ESETTING THE SAW CHAINSharpen lower edgeDrive linkTie strapRight hand cutterPreset tie strapLeft hand cutterGuard linkTop plateSide pl

Page 22 - TESTING THE BRAKE

27CS-8000 TYPE1-ENOTEThese angles are referred to as Oregon 72LPXor 72LGX. To sharpen other follow chainmanufacturer’s instruction.• Place the depth g

Page 23 - SAW CHAIN

1CS-8000 TYPE1-ERULES FOR SAFE OPERATIONA. Kickback Safety Precautions for Chain Saw Users 1.With a basic understanding ofkickback, you can reduce or

Page 24 - MAINTENANCE AND CARE

28CS-8000 TYPE1-ETROUBLESHOOTINGProblemEngine — hard to start Cause Remedy— does not startEngine Fuel at No fuel • Fuel filter clogged • Clean or repl

Page 25 - CARBURETOR ADJUSTMENT

29CS-8000 TYPE1-EMODEL CS-8000 TYPE1-EDimension L × W × H mm 421 × 244 × 311 (15.5 in. × 9.6 in. × 10.9 in.)Mass Power head, dry kg 7.5 (16.5 lb.) Wi

Page 27 - AUTOMATIC OILER

2CS-8000 TYPE1-E 1.Do not operate a chain saw with onehand! Serious injury to the operator,helpers, bystanders, or anycombination of these persons ma

Page 28 - SETTING THE SAW CHAIN

3CS-8000 TYPE1-E WARNINGThe safety alert symbol accompanied by theword “WARNING” calls attention to an act orcondition which CAN lead to seriouspers

Page 29

4CS-8000 TYPE1-ETO AVOID KICKBACK1. Hold the chain saw firmly with bothhands.2. Don’t let the nose of the guidebar contact any obstruction.3. Tip cont

Page 30 - TROUBLESHOOTING

5CS-8000 TYPE1-EPACKING LISTThe ECHO product you purchased has beenfactory pre-assembled for your convenience. Due topackaging restrictions, guide bar

Page 31 - TECHNICAL DATA

6CS-8000 TYPE1-E NOMENCLATURE OF PARTS21* If a decal cannot be read, a new one can beordered from your ECHO dealer.TO AVOID KICKBACK1. Hold the chai

Page 32

7CS-8000 TYPE1-ENOMENCLATURE OF PARTS 1. Instruction manual - Included with unit.Read before operation and keep for futurereference to learn proper,

Commentaires sur ces manuels

Pas de commentaire